Sunil,K Narayanankutty(Elsevier Science Publishers Ltd., August 29, 1991)
[+]
[-]
Abstract:
The thermal degradation of short kevlar fibre-thermoplastic polyurethane
(TPU) composites has been studied by Thermogravimetric Analysis (TGA)
and Differential Scanning Calorimetry (DSC). TGA showed that the thermal
degradation of TPU takes place in two steps with peak maxima (T1max and
T2ma,) at 383°C and 448°C, respectively. In the presence of 10-40 phr of short
kevlar fibres, T1_ and T2max were shifted to lower temperatures. The
temperature of onset of degradation was increased from 245 to 255°C at 40
parts per hundred rubber (phr) fibre loading. Kinetic studies showed that the
degradation of TPU and kevlar-TPU composite follows first-order reaction
kinetics. The DSC study showed that there is an improvement in thermal
stability of TPU in the presence of 20 phr of short kevlar fibres.
Sunil,K Narayanankutty(Elsevier Science Limited, May 17, 1997)
[+]
[-]
Abstract:
The thermal degradation of short polyester fiber reinforced polyurethane composites
with and without different bonding agents has been studied by thermogravimetric
analysis . It was found that degradation of the polyurethane takes
place in two steps and that of the composites takes place in three steps. With
the incorporation of 30 phr of fiber in the matrix , the onset of degradation was
shifted from 230 to 238 ° C. The presence of bonding agents in the virgin elastomer
and the composite gave an improved thermal stability . Results of kinetic studies
showed that the degradation of polyurethane and the reinforced composites with
and without bonding agents follows first -order reaction kinetics
The cure characteristics of short fiber-polyurethane elastomer
were studied with respect to different fiber-matrix bonding agents. A hexamethylenetetramine-
resorcinol -hydrated silica based bonding agent was found to affect
the stability of the composite. A new bonding agent, TP resin, based on polymeric
toluenediisocyanate and polypropylene glycol has been developed. Cure characteristics
of the composite with and without TP resin at different fiber loadings were
also compared. Minimum torque, scorch time and optimum cure time increased
with fiber content. Maximum torque was consistently higher with TP resin at all
fiber loadings.
Sunil,K Narayanankutty(Technomic Publishing Co., Inc., April , 1998)
[+]
[-]
Abstract:
The stress relaxation behavior of polyurethane elastomer and
short polyester fiber filled elastomer composites with and without bonding
agents at different strain levels and strain rates was studied. It was found that
these compounds exhibit a multistage relaxation mechanism and that the rate
of relaxation and cross-over time depend on the strain level and strain rate.
The incorporation of fibers reduced the stage-I relaxation rate and increased
the cross-over time of the gum vulcanisate. A higher rate of relaxation (first
stage) was shown by the composites with longitudinal fiber orientation and
composites with bonding agents.
The rheological behavior of a short-polyester-fiber-filled polyurethane
elastomer composite containing different bonding agents
has been studied in the temperature range 120-160°C and in the
shear rate range 63-608 s-'. The composite with and without
bonding agents showed a pseudoplastic behavior which decreased
with the increase of temperature. Composites containing bonding
agents based on polypropyleneglycol and 4,4'-diphenylmethanediisocyanate
showed the lowest viscosity values at a particular
shear rate, whereas composites containing a glycerol- (GL) based
bonding agent showed the highest viscosity. The viscosity of the
composite decreased sharply after a particular temperature (140°C) and the fall was less drastic in the composite containing
a GL-based bonding agent.